cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
885
Views
0
Helpful
2
Replies

Does Cisco Configuration Professional (CCP) required CDP to be run on the routers?

clifford.gormley
Beginner
Beginner

Hello,

I have five Cisco ISR G2 2921 routers, and I want to be able to manage them with Cisco Configuration Protocol.

1. Do I need to have Cisco Discovery Protocol (CDP) enabled to utilize a "topology-map creator" within the CCP to create a topology map?  (I am not even sure if this is a feature of CCP)

2. Do I need any ports open on the router to use CCP, ie. http, https, etc.?

Thanks,
Cliff

1 Accepted Solution

Accepted Solutions

Reza Sharifi
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

Hi,

For CCP, you need to enable these commands:

Step 2. Enable the router HTTP or HTTPS server using the following Cisco IOS Software commands.

If  HTTP and HTTPS are enabled and configured to use nonstandard port  numbers, you can skip this step and simply use the port number already  configured.

Router(config)# ip http server

Router(config)# ip http secure-server

Router(config)# ip http authentication local

You also need IOS 15 on the router.

HTH

View solution in original post

2 Replies 2

Reza Sharifi
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

Hi,

For CCP, you need to enable these commands:

Step 2. Enable the router HTTP or HTTPS server using the following Cisco IOS Software commands.

If  HTTP and HTTPS are enabled and configured to use nonstandard port  numbers, you can skip this step and simply use the port number already  configured.

Router(config)# ip http server

Router(config)# ip http secure-server

Router(config)# ip http authentication local

You also need IOS 15 on the router.

HTH

You are great!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers