cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
653
Views
5
Helpful
5
Replies

Does N9300k FX2 support Per Vlan Statistics? Im not able to see the counters on VLAN interface.

r.aneeshc
Level 1
Level 1

I'm having an issue with identifying the traffic load on Vlan interface on my N9k FX2 (specifically C93360YC-FX2).. Show interface Vlan XXX displays with the traffic shown as :- ucast: 0 pkts, 0 bytes. Please can someone explain if this is expected behaviour or not?

 

Many thanks in advance.

1 Accepted Solution

Accepted Solutions

Sergiu.Daniluk
VIP Alumni
VIP Alumni

Hi,

Seems like not, due to following bug: https://quickview.cloudapps.cisco.com/quickview/bug/CSCvp32970 

Symptom:
SVI counters do not work on N9K-C93240YC-FX2 even with "hardware profile svi flex-stats-enable" applied.

Known Affected Releases
9.2(3) 9.3(1) 

Regards,

Sergiu

View solution in original post

5 Replies 5

Reza Sharifi
Hall of Fame
Hall of Fame

Does vlan xxx have an IP associated with? Is the IP the gateway for a user or server vlan traffic?

HTH

Thanks, Reza for the response.

 

Yes, it is having an IP associated (SVI Interface) and used for establishing an eBGP peering having active traffic flow.

 

********For reference output state as below************

VlanXXX is up, line protocol is up, autostate enabled
Hardware is EtherSVI, address is XXXXX
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA
Last clearing of "show interface" counters never
L3 in Switched:
ucast: 0 pkts, 0 bytes : >>>  This is the part which concern me at this point

****************************

Many thanks.

Hi,

Do you see traffic on the physical interface that is peering BGP? If yes, not seeing traffic on the vlan interface may not be an issue.

HTH

Sergiu.Daniluk
VIP Alumni
VIP Alumni

Hi,

Seems like not, due to following bug: https://quickview.cloudapps.cisco.com/quickview/bug/CSCvp32970 

Symptom:
SVI counters do not work on N9K-C93240YC-FX2 even with "hardware profile svi flex-stats-enable" applied.

Known Affected Releases
9.2(3) 9.3(1) 

Regards,

Sergiu

Many thanks, Sergiu for the response and explanation. it really helps.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: