12-03-2013 04:07 AM - edited 03-07-2019 04:54 PM
Hi,
We are seeing our wired devices on our Packetfence controlled network being prompted for credentials each time they are plugged in/turned on/rebooted, and often the credentials are being rejected.
Radius debug logs show that Access-Accept is being sent to the device, but the device is not ever getting onto the network.
Enabling debug on my Cisco 2960 test switch I can see the error below:
%DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address
The reason I don’t think that this is a packetfence/radius issue is that we’re not having any issues with wireless clients.
I hope someone can help.
Jamie.
12-03-2013 04:33 AM
Hi,
Regards
Alain
Don't forget to rate helpful posts.
12-03-2013 05:45 AM
Thanks for the reply.
I looked at the MAC address table but it isn't full. I think that error may be a "red herring" because I have debug running on another switch and a user just had the same problem but the "%DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address" didn't appear???
cadet alain wrote:
Hi,
Regards
Alain
Don't forget to rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide