I recently acquired a Cat 4507R, and in going thru the docs I wanted to update the embedded ciscoview to the latest version. I was following the directions in the PDF showing to deleted any existing CV files then to tftp the new tar to the switch, but when following the link for the tar to load onto the switch it tells me that the link is no good...?? Can someone provide a link to the current embedded ciscoview tar. I just deleted the current files and need to get the new ones so I can get the embedded ciscoview working again...
I am running the following:
SPS4507_01#sh ver
Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I9S-M), Version 12.2(25)EWA4, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Fri 23-Sep-05 13:31 by ssearch
Image text-base: 0x10000000, data-base: 0x114DFF08
ROM: 12.2(20r)EW1
Dagobah Revision 226, Swamp Revision 31
SPS4507_01 uptime is 5 days, 2 hours, 8 minutes
Uptime for this control processor is 5 days, 2 hours, 8 minutes
System returned to ROM by power-on
System restarted at 11:59:42 pst Thu Dec 30 2010
System image file is "bootflash:"
cisco WS-C4507R (MPC8245) processor (revision 14) with 524288K bytes of memory.
Processor board ID FOX101116NQ
MPC8245 CPU at 333Mhz, Supervisor IV
Last reset from PowerUp
12 Virtual Ethernet interfaces
202 Gigabit Ethernet interfaces
403K bytes of non-volatile configuration memory.
Configuration register is 0x2101
Thanks for you help in advance.
