cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
582
Views
0
Helpful
6
Replies
Highlighted
Beginner

Dual-homing stackwise virtual pair to the ISP router

Current setup is (one) core switch 6509 with default route to (one) ISP router( isp router not under my administration, i have to ask for specific configuration changes).

 

Soon We will migrate the core to stackwise virtual pair of c9407s.

 

How do i achieve dual homing to the same ISP ,  incase active switch fails ?

6 REPLIES 6
Highlighted
VIP Mentor

If the Device is Singled Home connection you will not get that HA availability.

 

What you can do from Up-link router have 2 Interface, stretch that to other switch in theirs case you are sure, it is fully meshed and resilience can be taken care.

 

BB
*** Rate All Helpful Responses ***
Highlighted

What about doing a layer 3 ether channel from SW1 and SW2 in stackwise virtual core to the ISP router ?

Highlighted
Beginner

We have also possibility to connect SW1 and SW2 with two separate links to two separate ISP routers but not sure how can i do this...

Highlighted

Do you have 2 routers for ISP, or both ISP terminating with 1 router.

 

what is the existing arrangement.

 

If have only 1 router, 1st image you provided should for you.

If you have 2 routers, that need also required dual homes connection to south bound switches to get resilience setup.

 

 

BB
*** Rate All Helpful Responses ***
Highlighted

Hello
Unfortunaley not enough information at this time to provide an acurate suggestion howerver you have options to employ various desgins for HA even routing resilency but for that can you provide some more detail surrounding the connectivity towards your ISPs.

 

 



kind regards
Paul

Please rate and mark posts accordingly if you have found any of the information provided useful.
It will hopefully assist others with similar issues in the future
Highlighted

@paul driver 

@balaji.bandi 

Single ISP: Dual links, Dual routers at both ends

 

The connectivity towards ISP router is via a static default route currently. 

 

What are my config options when i connect our new core switches(stackwise virtual) with 2 different ISP routers of single provider ? I understand i had to use bgp ?

 

What bgp config would be ideal in my senario ?

Content for Community-Ad