cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
510
Views
0
Helpful
2
Replies

dual SUP720 with 10G line card

jayshihlin
Level 1
Level 1

Maybe its by design but just my curiosity since this our first 10G line card...  After insert 10G and put in production, when I ran show mac-add from 10g interface I only see list off mac address from module 9 (slot i had 10g line card insert).  but if i ran show mac-add from other 1G line card I see the same mac address from active supervisor and standby supervisor.

Thanks,

=JL=

2 Replies 2

jasonfmic
Level 1
Level 1

Which 10GE card are you using? Is it a DFC?

It's a WS-F6700-DFC3C

Thanks,

=JL=

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco