Embedded packet capture: 2960 LANBASE

[Bob Greer]

Hi there,

Thanks for reading.

The switch is running 15.0(2)SE6

I'm seeing 0 byte counts on my buffer.  The switch accepts these commands:

config terminal

ip access-list extended CAP-FILTER

   permit ip any any

   exit

exit

monitor capture buffer CAP-BUF max-size 7000

monitor capture buffer CAP-BUF filter access-list CAP-FILTER

monitor capture point ip cef CAP-POINT f0/29 both

monitor capture point associate CAP-POINT CAP-BUF

monitor capture point start CAP-POINT

Does this IOS need a local destination port?  There's 16MB free on the flash.  What am I doing wrong?

Thanks!

Bob

[Reza Sharifi · Accepted solution]

Hi,

Not sure if the 2960 series with lan base license support it but this link has sample config for the 3850 series that maybe helpful.

https://supportforums.cisco.com/document/12013221/using-3850-embedded-wireshark-wired

HTH