enable password when configure aaa new model

[aafarha]

hello all,

I have a cisco switch and I need to connect authentication by windows radius server 2019, I configure the server and try to enable aaa in the switch.

I type  aaa new-model

radius server .....

only this commend after reconnect to switch I see enable mode in the switch, I don't have any enable or password for this !!! how can I remove this restriction from radius server  2019 or another way ?

thank you 

[Reza Sharifi]

Hi 

Have a look at this link:

https://www.reddit.com/r/Cisco/comments/3w2pvy/radius_authentication_with_enable_password_cisco/

HTH

[aafarha]

hello Reza, 

from the document, the enable password is known! but in my case, I don't know and don't configure the enable password.

the enable was created enabled by default when I enable aaa new-model 

[Reza Sharifi]

Hi,

If you don't have the password, then you may have to do a password recovery to reset the password.

HTH