03-22-2020 06:25 PM
I have Cisco 2960 switch. I want to enable POE+ on this switch.
Is there any special command which will enable POE+ in the switch ? If so please let me know how to enable POE+
Solved! Go to Solution.
03-24-2020 09:56 PM
03-24-2020 10:10 PM - edited 03-24-2020 11:09 PM
Like I said before, configure the port for 25.0w.
03-25-2020 01:46 AM
Is this the right syntax
power inline static max 25000
03-25-2020 02:38 AM
03-23-2020 12:18 AM
For LLDP support does both the switch port & the end device should support LLDP or only the switch port should switch port.
03-25-2020 03:22 AM
Post the output of the command 'show power inline gigabitEthernet x/y detail'
This should show you what type of PD the switch thinks is connected.
03-22-2020 07:55 PM - edited 03-22-2020 07:57 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: