08-21-2015 11:04 AM - edited 03-08-2019 01:27 AM
Hello everyone,
I have a question about enabling SDM on SW 3750 in stack system. The question is..How can I enable the SDM on stack Switches? Do I need enabling on both switches or only on stack-wise virtual switch?
Thanks in advance.
Solved! Go to Solution.
08-23-2015 03:42 PM
Hello Erico,
If the switches are already stacked, then you will only need to enable on the master.
If they are not, after the switches become stacked, the master template will be overridden.
You can take a look at the following links for more information:
Regards,
Mohammad
08-23-2015 03:42 PM
Hello Erico,
If the switches are already stacked, then you will only need to enable on the master.
If they are not, after the switches become stacked, the master template will be overridden.
You can take a look at the following links for more information:
Regards,
Mohammad
08-25-2015 08:48 AM
Hello Mohammad,
Thank you so much for your response, this document is so useful.
Regards
Érico
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide