cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 
cancel
5083
Views
5
Helpful
3
Replies

encpsulation dot1q - trunk SG300 issue

mbaqi0001
Level 1
Level 1

I have SG300-28 28-Port Gigabit Managed Switch (Firmware version: 1.3.0.62 ). I'd like to create a trunk port to allow VLan ID 300, and here is my configuration

#int gi3
#no negotiation
#switchport mode trunk
#switchport trunk allowed vlan add 300
#spanning-tree portfast
#exit

And I'd like to enable encapsulation dot1q on that trunk "#switchport trunk encapsulation dot1q" but it is not allowed on this Cisco ("unrecongized command").I actually I will send the packet from Esxi which supports only dot1q not ISL

Any help would be greatly appreciated. Thanks

2 Accepted Solutions

Accepted Solutions

Ganesh Hariharan
VIP Alumni
VIP Alumni

Hi,

Check out the below link , Hope that Helps.

Cisco SG 200 Trunking

Hope it Helps..

-GI

View solution in original post

This is normal. SG300 switch doesn't support ISL protocol, so there is no need in the command "switchport trunk encapsulation <trunk_protocol>". All trunk interfaces use dot1q to encapsulate ethernet frames on SG300.

View solution in original post

3 Replies 3

Ganesh Hariharan
VIP Alumni
VIP Alumni

Hi,

Check out the below link , Hope that Helps.

Cisco SG 200 Trunking

Hope it Helps..

-GI

This is normal. SG300 switch doesn't support ISL protocol, so there is no need in the command "switchport trunk encapsulation <trunk_protocol>". All trunk interfaces use dot1q to encapsulate ethernet frames on SG300.

Thank you so much for your reply. Vlan is always up "no shutdown" by default ? as it is the same thing "unrecongized command" on the Switch.

Review Cisco Networking for a $25 gift card