cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1059
Views
0
Helpful
5
Replies

errdisable - how to disable timer

karlstetter1
Level 1
Level 1

hi,

i can find many information how to auto-recover a port with enabled errdisable recovery on a cisco 2960x.

But how can disable the timer for a special cause.

thanks for answers

gunther

5 Replies 5

Mark Malone
VIP Alumni
VIP Alumni

Hi

if you don't want err-disable to kick in , just do a no infront of it or maybe set the intervals longer to pause the recovery

CORE.CA.23(config)#errdisable recovery interval ?
  <30-86400>  timer-interval(sec)

Glenn Martin
Cisco Employee
Cisco Employee

moving this discussion to the appropriate community for greater visibility.

Adrian Jimenez
Cisco Employee
Cisco Employee

Hi Karlstetter1,

Disabling the timer for a particular cause it's easy, just go with: 

Switch(config)#no errdisable recovery cause <cause>

You cannot configure different timer intervals for different causes,though. One time interval will rule all the causes. 

Hope it helps.  

AJ

Hi Adrian,

thanks a lot!

Sometimes the solution is just to near to see it.

Thank you

gunther

Sure anytime! 

AJ

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco