06-18-2021 10:33 PM - edited 06-19-2021 10:46 AM
I am trying to upgrade a C9300-48-UXM-E from IOS XE 16.12.03a to IOS XE 17.03.03.
I have followed all of the prerequisites and when I issue the following command:
request platform software package install switch all file flash:cat9k_iosxe.17.03.03.SPA.bin auto-copy
I get the following error:
--- Starting install local lock acquisition on switch 1 ---
Finished install local lock acquisition on switch 1
FAILED: Cannot determine list of packages for installation.
C9300_Stack_Member_3#
I have searched and I cannot find any referral to this error let alone determining it's cause.
Any help would be greatly apprciated.
06-18-2021 11:11 PM
Use the "force" option.
06-19-2021 10:31 AM
force option makes no difference.
Thx
Bryan
06-19-2021 05:37 PM
dir sh boot
06-18-2021 11:19 PM
Try installing for 1 switch at a time also can you try the new auto-copy command and see if it helps?
## Make sure to mark post as helpful, If it resolved your issue. ##
06-19-2021 09:55 AM
Hi Mohsiala,
I am only doing this on a non stack switch to test the upgrade before updating the stack and then adding this switch to the stack.
Thx
Bryan
06-19-2021 10:33 AM
Also, I am not sure what you mean by the new auto-copy command. I am using the auto-copy parameter.
What is this error trying to tell me?
06-19-2021 01:56 AM
what is the exiting installation bundle or install mode?
just to clarify are you doing upgrade standalone or stack "why i have asked - because " C9300_Stack_Member_3
if you upgrading stack you need to use
request platform software package install switch all file flash:newimage.bin new auto-copy
06-19-2021 09:58 AM
BB
This will be come the 3rd stack member but right now it is a single switch
Thx
Bryan
06-19-2021 11:11 AM
can you post show version and dir
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: