cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
725
Views
0
Helpful
2
Replies

Errors establishing ISDN communication

SERGIO L
Level 1
Level 1

I need some help.  I'm trying to dial a Cisco 1841 BRI from my Cisco 2811 PRI.  I'm getting a few errors but not sure what else to do to correct the issue.  Config & Logs below from 1841:


interface BRI0/0/0
no ip address
encapsulation ppp
dialer pool-member 2
isdn switch-type basic-ni
isdn point-to-point-setup
no cdp enable
ppp authentication chap callin


interface Dialer1
description ISDN to DAL
ip unnumbered Loopback1
encapsulation ppp
dialer pool 2
dialer remote-name DAL-R1-ISDN2811
dialer string 1214#######
ppp authentication chap callin


00:26:44: ISDN BR0/0/0 Q931: RX <- SETUP pd = 8  callref = 0x46
Bearer Capability i = 0x8890
  Standard = CCITT
  Transfer Capability = Unrestricted Digital
  Transfer Mode = Circuit
  Transfer Rate = 64 kbit/s
Channel ID i = 0x89
Signal i = 0x40 - Alerting on - pattern 0 
Called Party Number i = 0xC1, '452####'
  Plan:ISDN, Type:Subscriber(local)
Locking Shift to Codeset 5
Codeset 5 IE 0x2A  i = 0x808001039E05, 'From ', 0x8B0C, '214 ###-####', 0x8001, '<'
00:26:44: ISDN BR0/0/0 SERROR: L2_Go: at bailout DLCB is NULL
L2: sapi 0 tei 127 ces 0 ev 0x3
00:00:111669149696: ISDN BR0/0/0 EVENT: process_rxstate: ces/callid 1/0x18 calltype 1 HOST_INCOMING_CALL
00:00:111669149696: ISDN BR0/0/0 EVENTd: isdn_get_guid: Got Guid 36B2001B8016
00:00:111669149696: ISDN BR0/0/0 EVENT: host_incoming_call: call_id 0x0018, Guid = 36B2001B8016 bchan 0
00:00:111669149696: ISDN BR0/0/0 EVENTd: calltrkr_incoming_call: call_id=0x18
00:00:111669149696: ISDN BR0/0/0 EVENTd: calltrkr_setup_received: isdn_info=1663448752l, call_id=0x18 ANSWER
00:00:111669149696: ISDN BR0/0/0 EVENTd: calltrkr_setup_received: calltracker disabled
00:00:111669149696: ISDN BR0/0/0 EVENTd: host_incoming_call: (non-POTS) DATA call
00:00:111669149696: ISDN BR0/0/0 EVENTd: calltrkr_setup_received: isdn_info=1663461776l, call_id=0x18 ANSWER
00:00:111669149696: ISDN BR0/0/0 EVENTd: host_incoming_call: (1) call_type is DATA
00:00:111669149696: ISDN BR0/0/0 EVENTd: host_incoming_call: voice_answer_data = FALSE call type is DATA
00:00:111669149696: ISDN BR0/0/0 EVENTd: host_incoming_call: Received a DATA call from 214####### on B1 at 64 Kb/s
00:00:111669149696: ISDN BR0/0/0 EVENTd: host_incoming_call: Accepting call call id 0x18
00:00:111669149696: %DIALER-6-BIND: Interface BR0/0/0:1 bound to profile Di1
00:00:111669149696: ISDN BR0/0/0 EVENTd: isdn_fromdialer: RM returned call_type 0 resource type 0 response 2
00:00:111669149696: ISDN BR0/0/0 EVENT: UserIdle: callid 0x18 received ACCEPT_CALL (0x13)
00:00:111669149696: ISDN BR0/0/0 EVENTd: isdn_send_connect: msg 4, call id 0x18, ces 1 bchan 0, call type DATA
00:00:111669149696: ISDN BR0/0/0 EVENTd: isdn_report: callid 0x18
00:00:111669149696: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to up
00:00:111669149696: %ISDN-6-CONNECT: Interface BRI0/0/0:1 is now connected to 214####### N/A
00:26:44: ISDN BR0/0/0 Q931: TX -> CALL_PROC pd = 8  callref = 0xC6
Channel ID i = 0x89
00:26:44: ISDN BR0/0/0 Q931: TX -> CONNECT pd = 8  callref = 0xC6
Channel ID i = 0x89
00:26:44: ISDN BR0/0/0 Q931: RX <- RELEASE_COMP pd = 8  callref = 0x46
Cause i = 0x8295 - Call rejected
00:00:111669149696: ISDN  EVENTd: cc_clear_free_list freeing 0x63212140
00:00:111669149696: ISDN BR0/0/0 EVENT: process_rxstate: ces/callid 1/0x18 calltype 1 HOST_DISCONNECT_ACK
00:00:111669149696: ISDN BR0/0/0 EVENTd: process_rxstate: cause=0x15 (21), cause_present=1
00:00:111669149696: ISDN BR0/0/0 EVENTd: calltrkr_call_cleared: isdn_info=0x632636B0, call_id=0x18
00:00:111669149696: ISDN BR0/0/0 EVENTd: calltrkr_call_cleared: isdn_info=0x63266990, call_id=0x18
00:00:111669149696: ISDN BR0/0/0 EVENTd: calltrkr_call_cleared: isdn_info=0x63266990, call_id=0x18
00:00:111669149696: ISDN BR0/0/0 EVENTd: calltrkr_call_cleared: isdn_info=0x632636B0, call_id=0x18
00:00:111669149696: ISDN BR0/0/0 EVENTd: host_disconnect_ack: call type is DATA
00:00:111669149696: ISDN BR0/0/0 EVENTd: isdn_report: callid 0x18
00:00:111669149696: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to down
00:00:111669149696: %DIALER-6-UNBIND: Interface BR0/0/0:1 unbound from profile Di1
00:26:44: ISDN BR0/0/0 Q931: RX <- RELEASE_COMP pd = 8  callref = 0x46
Cause i = 0x8295 - Call rejected
00:00:111669149696: ISDN BR0/0/0 SERROR: L3_GetUser_NLCB: EVENT 0X5A No NLCB 2
00:00:111669149696: ISDN BR0/0/0 **ERROR**: L3_BadPeerMsg: event 0x5A cr 0xC6 callid 0x0

2 Replies 2

Sandeep Choudhary
VIP Alumni
VIP Alumni

HI Sergio,

Please insert one command under dialer interface:

ppp authentication chap callin

and then try.If still the same issue then please paste the out put of these commands:

debug ppp neg

debug ppp auth

Regards

Please rate if it helps.

interface Dialer1 already has ppp authentication chap callin.  Debug below...

11529215046068469760d21474836480h: %DIALER-6-BIND: Interface BR0/0/0:1 bound to profile Di1

11529215046068469760d21474836480h: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to up

11529215046068469760d21474836480h: %ISDN-6-CONNECT: Interface BRI0/0/0:1 is now connected to 214####### N/A

5d22h: BR0/0/0:1 PPP: Using dialer call direction

5d22h: BR0/0/0:1 PPP: Treating connection as a callin

5d22h: BR0/0/0:1 PPP: Session handle[C000055] Session id[69]

5d22h: BR0/0/0:1 PPP: Phase is ESTABLISHING, Passive Open

5d22h: BR0/0/0:1 LCP: State is Listen

11529215046068469760d21474836480h: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to down

11529215046068469760d21474836480h: %DIALER-6-UNBIND: Interface BR0/0/0:1 unbound from profile Di1

5d22h: BR0/0/0:1 LCP: State is Closed

5d22h: BR0/0/0:1 PPP: Phase is DOWN

11529215046068469760d21474836480h: %DIALER-6-BIND: Interface BR0/0/0:1 bound to profile Di1

11529215046068469760d21474836480h: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to up

11529215046068469760d21474836480h: %ISDN-6-CONNECT: Interface BRI0/0/0:1 is now connected to 214####### N/A

5d22h: BR0/0/0:1 PPP: Using dialer call direction

5d22h: BR0/0/0:1 PPP: Treating connection as a callin

5d22h: BR0/0/0:1 PPP: Session handle[42000056] Session id[70]

5d22h: BR0/0/0:1 PPP: Phase is ESTABLISHING, Passive Open

5d22h: BR0/0/0:1 LCP: State is Listen

11529215046068469760d21474836480h: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to down

11529215046068469760d21474836480h: %DIALER-6-UNBIND: Interface BR0/0/0:1 unbound from profile Di1

5d22h: BR0/0/0:1 LCP: State is Closed

5d22h: BR0/0/0:1 PPP: Phase is DOWN

11529215046068469760d21474836480h: %DIALER-6-BIND: Interface BR0/0/0:1 bound to profile Di1

11529215046068469760d21474836480h: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to up

11529215046068469760d21474836480h: %ISDN-6-CONNECT: Interface BRI0/0/0:1 is now connected to 214####### N/A

5d22h: BR0/0/0:1 PPP: Using dialer call direction

5d22h: BR0/0/0:1 PPP: Treating connection as a callin

5d22h: BR0/0/0:1 PPP: Session handle[30000057] Session id[71]

5d22h: BR0/0/0:1 PPP: Phase is ESTABLISHING, Passive Open

5d22h: BR0/0/0:1 LCP: State is Listen

11529215046068469760d21474836480h: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to down

11529215046068469760d21474836480h: %DIALER-6-UNBIND: Interface BR0/0/0:1 unbound from profile Di1

5d22h: BR0/0/0:1 LCP: State is Closed

5d22h: BR0/0/0:1 PPP: Phase is DOWN

11529215046068469760d21474836480h: %DIALER-6-BIND: Interface BR0/0/0:1 bound to profile Di1

11529215046068469760d21474836480h: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to up

11529215046068469760d21474836480h: %ISDN-6-CONNECT: Interface BRI0/0/0:1 is now connected to 214####### N/A

5d22h: BR0/0/0:1 PPP: Using dialer call direction

5d22h: BR0/0/0:1 PPP: Treating connection as a callin

5d22h: BR0/0/0:1 PPP: Session handle[41000058] Session id[72]

5d22h: BR0/0/0:1 PPP: Phase is ESTABLISHING, Passive Open

5d22h: BR0/0/0:1 LCP: State is Listen

11529215046068469760d21474836480h: %LINK-3-UPDOWN: Interface BRI0/0/0:1, changed state to down

11529215046068469760d21474836480h: %DIALER-6-UNBIND: Interface BR0/0/0:1 unbound from profile Di1

5d22h: BR0/0/0:1 LCP: State is Closed

5d22h: BR0/0/0:1 PPP: Phase is DOWN

Issue still exists.      

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco