cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

145
Views
0
Helpful
1
Replies
Beginner

ES3G-24-P Recovery

Hello, 

I have a ES3G-24-P that i inadvertently loaded an unsupported switch image on, now when it boots it gets stuck in a loop and keeps trying to reload the failed IOS.  Is there a way to stop the boot process and get the module in rommon mode so i can point it to the correct boot image which is still in flash?  It is installed in a 2911.  Any help is greatly appreciated.  Thanks.  

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Expert

Re: ES3G-24-P Recovery

Hi,

Try following this document using password recovery section:

 

https://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/software/feature/guide/eesm_sw.html#pgfId-1931266

 

HTH

1 REPLY 1
VIP Expert

Re: ES3G-24-P Recovery

Hi,

Try following this document using password recovery section:

 

https://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/software/feature/guide/eesm_sw.html#pgfId-1931266

 

HTH

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards