We have two data centres connected by a 2 pairs of active resilient ( diverse) 1Gbit fibre circuits. At each DC the circuits connect into a 3750E stack,
each circuit connects to a different switch within the stack (interfaces G3/0/49 & G4/0/49). We are trunking Vlans over these links and have grouped them into a single Etherchannel using LACP but can't get the etherchannel to work. One interface on each switch always goes into suspended mode.
I am fairly confident that the config is correct on the stacks. There are two things that spring to mind which may be the problem. 1, My understanding is that LACP works with interfaces on different switches within the stacks but I may be wrong. 2, the pairs fibre links have different latency values due to the diverse routes taken . Route A is 70K route B is 100K one way trip times for both pairs are sub millisecond, could this be a factor?
I'd change the passive mode to active. No harm. I will look for other possibilities, too, but for now that's all I have.
Well, just thought of one other thing...make sure all the duplex and speeds matchup for all the ports. The nonegotiate for the port-channel interface seems unnecessary. I know they are all gig interfaces but I have seen strange things before.
When bringing up the ports bring them all up at the same time using a "no shut" on the port channel SVI . Post a " show etherchannel detail" for us to see what is going on . Also it will usually tell you in the logs why the port was put into a suspended state , you could post that too ..
Cisco Champion Radio · S7|E30 Taming Your AI/ ML Workloads with Kubeflow
As organizations increasingly introduce machine learning (ML) capabilities to their existing products, their artificial intelligence (AI) projects and operations complexity g...
Cisco IOS-XE 17.3.1 – Catalyst Switching Updates
Table of Contents
Hardware Additions since IOS-XE 17.2.1
Key Summary Features
Platform and Infra Features
High Availability Features
Routing / MPLS / VPN Features
Hi Everyone,I have 2 queries1. After we configure the IPSec VPN in a Cisco Router, how do we identify and check that the traffic is flowing through the tunnel? Are there any commands and ways to find it out?2. What are some of t...