02-18-2020 02:20 PM
I was learning Etherchannels where it said there are some prerequisite on the link that the interfaces should be same on speed, duplex, operational mode etc.
I put two interface on a switch into an etherchannel. Then I tried to change one interface to half duplex and 10 Mbps while other was 100Mbps and full duplex. The interfaces were still operational in the etherchannel as P ~ bundled in etherchannel.
Am I wrong in understanding that the speed and duplex of both interfaces should be same before they can be bundled in an etherchannel?
Thanks in advance.
02-18-2020 02:29 PM - edited 02-18-2020 02:31 PM
yes, you need to have same capacity 10MB or 100MB, you can not mix speed.
here is the good guide lines :
02-18-2020 05:00 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: