07-03-2017 02:42 AM - edited 03-08-2019 11:10 AM
Hi,
i have tried to configure the Ethernet OAM between Cisco switch and Huawei Switch, Pls find the below topology
Topology:
Problem Observed
Configurations:-
Cisco 4500:-
interface TenGigabitEthernet1/16
description XCNT-HUAWEI-124.7.227.57-Gi0/0/26
switchport trunk allowed vlan 400
switchport mode trunk
mtu 9198
speed nonegotiate
ethernet oam remote-loopback supported
ethernet oam remote-loopback timeout 10
ethernet oam timeout 10
ethernet oam link-monitor frame threshold high 10
ethernet oam link-monitor receive-crc threshold high 10
ethernet oam link-monitor high-threshold action error-disable-interface
ethernet oam remote-failure link-fault action error-disable-interface
ethernet oam remote-failure critical-event action error-disable-interface
ethernet oam
end
Huawei S5700:-
interface GigabitEthernet0/0/26
undo negotiation auto
description XCNT-4500X-SW-100.65.181.71-Te1/16
port link-type trunk
undo port trunk allow-pass vlan 1
port trunk allow-pass vlan 102 400
stp bpdu-filter enable
stp edged-port enable
efm enable
efm error-frame notification enable
efm error-frame-second notification enable
efm error-code notification enable
efm threshold-event trigger error-down
efm link-fault trigger error-down
efm timeout trigger error-down
07-03-2017 03:32 AM
06-20-2018 08:00 PM
HI anyone can help thi subject issue?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: