cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

251
Views
0
Helpful
1
Replies
Highlighted
Beginner

Excluding traffic from shaping?

Recently found out MPLS PE routers (Cisco GSRs) do not support weighted fair queuing.  Provider suggests putting a shaper mactching the WAN speed as an output policy on the LAN inteface on our CE router (managed by us) if we wanted to use weighted fair queuing.  On our LAN interface however, we have "ip wccp redirect in" for our WAAS appliance.  When we shape outbound on the LAN interface it is also shaping down the GRE flow for the WCCP redirect.  Is it possible to exclude the GRE traffic between the router and WAAS appliance from being shaped?

Config snippet attached for reference.

Thanks.

Jon

Everyone's tags (3)
1 REPLY 1
Highlighted
VIP Expert

Excluding traffic from shaping?

Disclaimer

The    Author of this posting offers the information contained within this    posting without consideration and with the reader's understanding that    there's no implied or expressed suitability or fitness for any  purpose.   Information provided is for informational purposes only and  should not   be construed as rendering professional advice of any kind.  Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In    no event shall Author be liable for any damages whatsoever  (including,   without limitation, damages for loss of use, data or  profit) arising  out  of the use or inability to use the posting's  information even if  Author  has been advised of the possibility of such  damage.

Posting

Most likely possible.  Might be as easy as defining a class in your parent policy for your GRE traffic.

CreatePlease to create content
Content for Community-Ad