06-17-2008 04:15 AM - edited 03-05-2019 11:40 PM
Hi, all.
Give me informations on access list for NAT.
Cisco IOS Master Command List, Release 12.4 describes the ip nat inside destination command, the ip nat inside source command, and the ip nat outside source command use standerd IP access list for dynamic NAT.
But the document follws uses extended IP access list for dynamic NAT in Difference between One-to-One Mapping and Many-to-Many section.
They leave me in confusion.
Regards
Solved! Go to Solution.
06-17-2008 05:39 AM
Hi,
Not specific to 12.4 but the below link will help for nat.
http://www.cisco.com/en/US/tech/tk648/tk361/tk438/tsd_technology_support_sub-protocol_home.html
Regards,
Pravin
06-17-2008 04:20 AM
>But the document follws uses extended IP access list for dynamic NAT in Difference between One-to-One Mapping and Many-to-Many section.
Hyperlinking slipped my mind.
http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080094e77.shtml
Regards
06-17-2008 05:39 AM
Hi,
Not specific to 12.4 but the below link will help for nat.
http://www.cisco.com/en/US/tech/tk648/tk361/tk438/tsd_technology_support_sub-protocol_home.html
Regards,
Pravin
06-19-2008 05:36 AM
Thanks for your advice.
Regards,
haa33110
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide