cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2704
Views
0
Helpful
3
Replies

Failover with "rtr" command

aparikh
Beginner
Beginner

I have 6513 - s72033_rp-ENTSERVICESK9_WAN-M), Version 12.2(18)SXF17a           

.

I want to do failover to the backup ISP with the "rtr" command (btw - ip sla command isnot available).

I can configure

rtr 2

type echo protocol ipIcmpEcho 4.2.2.2

rtr schedule 2 life forever start-time now

but - ip route 0.0.0.0 0.0.0.0 x.x.x.x track 1 (MISSING).

can someone show me the complet  failover configuraiton with "rtr" command ?

3 Replies 3

srikanth ath
Enthusiast
Enthusiast

Hello,

Try this

rtr 1

type echo protocol ipicmpecho x.x.x.x ---> Configures an SAA end-to-end echo response time probe operation.

rtr schedule 1 life forever start-time now  --> Configures the time parameters for the SAA operation.

track 123 rtr 1 reachability--> Configures the time parameters for the SAA operation.

  delay up 60 down 30 --->  Specifies a period of time (in seconds) to delay communicating state changes of a tracked object.

ip route 0.0.0.0 0.0.0.0 x.x.x.x track 123

USe this link:http://www.cisco.com/en/US/docs/ios-xml/ios/iproute_pi/configuration/12-4t/iri-pbr-mult-track.html

Let us know if you require anything more.

Regards,

srikanth

***  PLease rate helpfull posts ***

Following two commands are not available in the 6513 IOS -  Version 12.2(18)SXF17a

track 123 rtr 1 reachability

ip route 0.0.0.0 0.0.0.0 x.x.x.x track 123

Hmm.. without the track command you cannot achieve the failover with IP-sla.

Regards

srikanth

Please rate the helpful posts.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers