cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
327
Views
0
Helpful
1
Replies

Firewall & Switches

sachinc01
Beginner
Beginner

Dear Sir,

I have following device ASA5508-FPWR-BUN X 1No
Catalyst 9300 48-port PoE+ X 3Switches now I want to configured 2 IP scope & DHCP for both IP scope on firewall & on the switch  2 VLAN .

On the Firewall I have configured 2 LAP IP (192.168.1.X,172.16.16.X)& also DHCP scope & firewall both cable connect to switch port 24 & 45, 46 -48 are the trunk port to connect another switches.

now on the switch I have configured 2 VLAN 172 & 192 port 1-24 port for 172 VLAN 24-45 port for 192 vlan.

I able to get DHCP & working but i have get both range ip through LAN or wifi which i not need i need only 192 scope for use & 172 range for CCTV only.

 

Can some one guide which configuration i will need or what changes i will need.........

1 Reply 1

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

as long as the en device connected to right access port they get respectected DHCP client IP.

can you post switch config. tell use where the cctv and other devices connected.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers