cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Ask the Expert- SD-WAN

230
Views
0
Helpful
3
Replies
Highlighted

Flash:/ in read only moder Cisco C3560 48-TS-S

Hello,

 

like in the topic written, i cannot reset the switch, because of the read only mode of the flash:/

 

i havent found any solution that worked for me.

 

can anyone help me?

 

switch: dir

List of filesystems currently registered:

xmodem[0]: (read-only)
null[1]: (read-write)
bs[3]: (read-only)
flash[18]: (read-only)
tftp[19]: (read-write)

 

 

These commands a possible:

 

switch: ?
? -- Present list of available commands
arp -- Show arp table or arp-resolve an address
boot -- Load and boot an executable image
cat -- Concatenate (type) file(s)
copy -- Copy a file
delete -- Delete file(s)
dir -- List files in directories
emergency-install -- Initiate Disaster Recovery
flash_init -- Initialize filesystem(s)
format -- Format a filesystem
fsck -- Check filesystem consistency
help -- Present list of available commands
mgmt_init -- initialize management port
mkdir -- Create dir(s)
more -- Concatenate (display) file(s)
ping -- Send ICMP ECHO_REQUEST packets to a network host
readrtc -- Read RTC
rename -- Rename a file
reset -- Reset the system
rmdir -- Delete empty dir(s)
set -- Set or display environment variables
set_bs -- Set attributes on a boot sector filesystem
set_param -- Set system parameters in flash
type -- Concatenate (type) file(s)
unset -- Unset one or more environment variables
version -- Display boot loader version
writertc -- Write RTC

 

 

Thanks for your help

Everyone's tags (3)
3 REPLIES 3
Hall of Fame Expert

Re: Flash:/ in read only moder Cisco C3560 48-TS-S

Hello Philip,

somebody else had the same issue on same model of switch

see the following thread

https://community.cisco.com/t5/switching/changeing-flash-from-read-only-to-read-write/m-p/3739978

 

it is similar to password recovery procedure.

 

Hope to help

Giuseppe

 

Hall of Fame Community Legend

Re: Flash:/ in read only moder Cisco C3560 48-TS-S

flash_init
load_helper

Re: Flash:/ in read only moder Cisco C3560 48-TS-S

hey,

 

thats why i started this thread.

 

the problem is, that the commands in the other topic are not available

 

switch: load_helper
Unknown cmd: load_helper

 

switch: set BYPASS_STARTUP_CONFIG=1
Can't set variable with illegal char "=" (0x3d) in name.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards