Frame Relay configuration example

[fb_webuser]

Do you have frame relay configuration example ?

Site to site where site A as Host and etc following site A use ISP media partner IP config DNS Server...

---

Posted by WebUser Janet Doe from Cisco Support Community App

[fb_webuser]

Check out these docs by Cisco

http://www.cisco.com/en/US/tech/tk713/tk237/tech_configuration_examples_list.html

---

Posted by WebUser Anamika Tiwari from Cisco Support Community App

[paul driver]

Hello

please review this  post, its show how to setup a bacis frame-relay switch and configure a  hub& spoke point-to-multipoint connection

res

Pau;l

https://supportforums.cisco.com/message/3894967#3894967

Please don't forget to rate any posts that have been helpful.

Thanks.

[Sruthi Pendam · Accepted solution]

Hello,

Could you please throw more light on what kind of FR config you are looking for :

1) Point-to-point

2) Point-to-mulpoint

3) PPPoFR

However if you are striclty looking for any just basic config , following can help :

http://www.cisco.com/warp/public/125/14.pdf

This gives an idea how FR configuration is done.

Following link gives more indepth details about frame-relay configuration and troubleshooting :

http://www.cisco.com/en/US/tech/tk713/tk237/technologies_tech_note09186a008014f8a7.shtml

Hope this helps .

Sruthi Pendam.

[sahseth]

Please find below Cisco link for same:

http://www.cisco.com/en/US/tech/tk713/tk237/technologies_tech_note09186a008014f8a7.shtml

Thanks.