cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
353
Views
0
Helpful
1
Replies
Highlighted
Beginner

Frame Relay w/ OSPF

Hello Everyone,

Here I am again, asking question. Why is it that I can't ping R3 loopback interface? But on other routers PING works fine.

R1# show ip ospf neighbor

Neighbor ID               Pri                    State                         Dead Time                Address                Interface

N/A                           0           ATTEMPT/DROTHER                    -                      10.1.1.4              Serial 0/0.12

2.2.2.2                       1          FULL/DR                              00:01:52                   10.1.1.3              Serial 0/0.12

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

I think your R1's config is not good. You have two FR subifs in the same IP subnet...

interface Serial0/0.12 multipoint

ip address 10.1.1.1 255.255.255.248

frame-relay map ip 10.1.1.3 102 broadcast

!

interface Serial0/0.13 multipoint

ip address 10.1.1.2 255.255.255.248

frame-relay map ip 10.1.1.4 103 broadcast

View solution in original post

1 REPLY 1
Highlighted
Beginner

I think your R1's config is not good. You have two FR subifs in the same IP subnet...

interface Serial0/0.12 multipoint

ip address 10.1.1.1 255.255.255.248

frame-relay map ip 10.1.1.3 102 broadcast

!

interface Serial0/0.13 multipoint

ip address 10.1.1.2 255.255.255.248

frame-relay map ip 10.1.1.4 103 broadcast

View solution in original post

Content for Community-Ad