05-19-2012 09:36 PM - edited 03-07-2019 06:48 AM
Hello Everyone,
Here I am again, asking question. Why is it that I can't ping R3 loopback interface? But on other routers PING works fine.
R1# show ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
N/A 0 ATTEMPT/DROTHER - 10.1.1.4 Serial 0/0.12
2.2.2.2 1 FULL/DR 00:01:52 10.1.1.3 Serial 0/0.12
Solved! Go to Solution.
05-20-2012 03:11 AM
I think your R1's config is not good. You have two FR subifs in the same IP subnet...
interface Serial0/0.12 multipoint
ip address 10.1.1.1 255.255.255.248
frame-relay map ip 10.1.1.3 102 broadcast
!
interface Serial0/0.13 multipoint
ip address 10.1.1.2 255.255.255.248
frame-relay map ip 10.1.1.4 103 broadcast
05-20-2012 03:11 AM
I think your R1's config is not good. You have two FR subifs in the same IP subnet...
interface Serial0/0.12 multipoint
ip address 10.1.1.1 255.255.255.248
frame-relay map ip 10.1.1.3 102 broadcast
!
interface Serial0/0.13 multipoint
ip address 10.1.1.2 255.255.255.248
frame-relay map ip 10.1.1.4 103 broadcast
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide