cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
360
Views
5
Helpful
2
Replies
Beginner

Fuji 16.9.x on 9300 - Flex connect APs

Hi all

Need some help around the port-security on 

 

Topology:

Wireless client > AP (flexconnect) > 9300 switch port > Core switch

 

My goal here is to enable port-security on the AP Native vlan.

I don't want to enable port-security on rest of the client vlans.

Port will be trunk port with AP vlan as native.

 

I have followed this url (as below), however it does not show how to enable port-security on just 1 vlan. Reason i say that, as i don't want wireless client affected or bound with the port-security, as wireless clients could be moving from one AP to another.

 

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/16-9/configuration_guide/sec/b_169_sec_9500_cg/b_169_sec_9500_cg_chapter_0101001.html

 

I believe in the previous version i.e. 12.2, there was option to specify the (as below) to enabled port security on just specific vlans but can't find similar in the latest version.

Switch(config-if)# vlan-range range

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/12-2/25sg/configuration/guide/conf/port_sec.html#wp1061883

 

Thank you.

MK

1 ACCEPTED SOLUTION

Accepted Solutions
Rising star

Re: Fuji 16.9.x on 9300 - Flex connect APs

you can configure port security for specified vlans (vlan-list):

   switchport port-security [maximum value [vlan {vlan-list | {access | voice}}]] 

View solution in original post

2 REPLIES 2
Rising star

Re: Fuji 16.9.x on 9300 - Flex connect APs

you can configure port security for specified vlans (vlan-list):

   switchport port-security [maximum value [vlan {vlan-list | {access | voice}}]] 

View solution in original post

Highlighted
Beginner

Re: Fuji 16.9.x on 9300 - Flex connect APs

Thank you.
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards