cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
885
Views
0
Helpful
2
Replies

GLBP - Both nodes want to be active, killing access to VLAN

lhoyle
Level 1
Level 1

We had an instance of both GLBP nodes (both 4510's) wanting to be active for a VLAN, stifling connectivity to that VLAN. The config's are below, but as a bandaid, we shut one of the sides? Is there anything glaringly wrong here?

Node A:

Current configuration : 308 bytes
!
interface Vlan1032
description Closet B

ip address 10.203.2.252 255.255.255.0
ip helper-address 10.201.0.112
ip helper-address 10.201.0.113
no ip redirects
ip pim sparse-dense-mode
shutdown
glbp 112 ip 10.203.2.254
glbp 112 priority 110
glbp 112 preempt
no glbp 112 load-balancing
end

R-A-01#sh glbp vlan 1032
Vlan1032 - Group 112
  State is Init (interface down)
    5 state changes, last state change 1d08h
  Virtual IP address is 10.203.2.254
  Hello time 3 sec, hold time 10 sec
  Redirect time 600 sec, forwarder time-out 14400 sec
  Preemption enabled, min delay 0 sec
  Active is unknown
  Standby is unknown
  Priority 110 (configured)
  Weighting 100 (default 100), thresholds: lower 1, upper 100
  Load balancing: disabled
  Group members:
    0024.9719.5eff (10.203.2.252) local
  There is 1 forwarder (0 active)
  Forwarder 2
    State is Init
      4 state changes, last state change 1d08h
    MAC address is 0007.b400.7002 (default)
    Owner ID is 0024.9719.5eff
    Preemption enabled, min delay 30 sec
    Active is unknown
    Arp replies sent: 12396

                  

Node G:

Current configuration : 257 bytes

!

interface Vlan1032

description Closet B

ip address 10.203.2.253 255.255.255.0

ip helper-address 10.201.0.112

ip helper-address 10.201.0.113

no ip redirects

ip pim sparse-dense-mode

glbp 112 ip 10.203.2.254

no glbp 112 load-balancing

end

R-G-01#sh glbp vlan 1032

Vlan1032 - Group 112

  State is Active

    42 state changes, last state change 1d08h

  Virtual IP address is 10.203.2.254

  Hello time 3 sec, hold time 10 sec

    Next hello sent in 2.624 secs

  Redirect time 600 sec, forwarder time-out 14400 sec

  Preemption disabled

  Active is local

  Standby is unknown

  Priority 100 (default)

  Weighting 100 (default 100), thresholds: lower 1, upper 100

  Load balancing: disabled

  Group members:

    0024.9719.6dbf (10.203.2.253) local

  There is 1 forwarder (1 active)

  Forwarder 1

    State is Active

      3 state changes, last state change 1d08h

    MAC address is 0007.b400.7001 (default)

    Owner ID is 0024.9719.6dbf

    Redirection enabled

    Preemption enabled, min delay 30 sec

    Active is local, weighting 100

    Arp replies sent: 1627

2 Replies 2

fb_webuser
Level 6
Level 6

Write a comment...

---

Posted by WebUser Sudheer Aluri from Cisco Support Community App

fb_webuser
Level 6
Level 6

Write a comment...

---

Posted by WebUser Sudheer Aluri from Cisco Support Community App

Review Cisco Networking products for a $25 gift card