11-25-2007 07:01 AM - edited 03-05-2019 07:36 PM
Hello!
plz Examine the Attached Topology!
i have 2 Distribution Connected togather Via L2 Link;GLBP Runing as a gateway Load Balency
cONFIGURATION LOOK LIKE THIS:
DS-1
int vlan 10
ip address 1.1.1.2 255.255.255.0
glbp 10 ip 1.1.1.1
glbp 10 priority 120
glbp 10 preempt
!
Ds-2
int vlan 10
ip address 1.1.1.3 255.255.255.0
glbp 10 ip 1.1.1.1
!
I HAVE Aplied this Config for 3 Vlans ..10 20 -30
now I have to Know if i need to configure STP FOR ALL VLAN'S..10-20-30.or its done bu default by STP
IF SO LET ME KNOW THE EXACT STP CONFIG?
10XS
11-29-2007 08:42 AM
freind!
what about If i have just DS1?
10XS
11-29-2007 11:28 AM
I Have 65 VLANS.I Will make DS1 root for the even vlan(12) and DS2 for ODD VLAN(11) now what is ur suggestion?
This will work, since you are load balancing as even as possible. Don't over complicated, send traffic from Vlan 1-32 to one distro switch and from 33-65 to the other.
As far as just using DS-1, that is a call for the network engineer that design your network to make.
But remember, you really don't want a single point of failure at any point in your network.
Best Regards
11-29-2007 12:35 PM
hello!
what about if i have RIGHT NOW Just DS1.do i need to configure this as a root for these vlans?10xs
11-29-2007 12:40 PM
Yes. It is still recommended that you set the Root Bridge manually, this will prevent the Access Layer Switches from becoming the root bridge.
Best Regards
11-29-2007 12:57 PM
root bridge for all vlans,right
10xs
11-29-2007 01:56 PM
Yes!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: