02-17-2010 09:18 PM - edited 03-06-2019 09:45 AM
Ok, I have this 2960G switch that is used for practice. but one of my fellow class mates deleted the whole configuration in the switch, is their any way to put it in to ROMmon mode to get the IOS back on the switch? any help would be deeply appreciated.
Solved! Go to Solution.
02-17-2010 10:33 PM
Ok, I have this 2960G switch that is used for practice. but one of my fellow class mates deleted the whole configuration in the switch, is their any way to put it in to ROMmon mode to get the IOS back on the switch? any help would be deeply appreciated.
Hi,
Check out the below link hope that help
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
If helpful do rate the post
Ganesh.H
02-17-2010 10:33 PM
Ok, I have this 2960G switch that is used for practice. but one of my fellow class mates deleted the whole configuration in the switch, is their any way to put it in to ROMmon mode to get the IOS back on the switch? any help would be deeply appreciated.
Hi,
Check out the below link hope that help
http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml
If helpful do rate the post
Ganesh.H
02-20-2010 05:21 PM
Thanks it worked PERFECTLY!!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: