05-09-2011 12:44 AM - edited 03-06-2019 04:57 PM
My Catalayst 4507 is reaching up to 82% CPU utilization and I noticed that K2L2 Address Table R is causing the high CPU, kindly help me to resolve this issue.
C4507#sh processes cpu | in HiPri|LoPri|CPU utilization
CPU utilization for five seconds: 82%/1%; one minute: 86%; five minutes: 87%
54 350533923 329104616 1065 13.27% 13.84% 13.86% 0 Cat4k Mgmt HiPri
55 1771768520 274992685 6442 59.91% 64.55% 66.04% 0 Cat4k Mgmt LoPri
C4507#sh platform health | in K2L2|%CPu
K2L2 Address Table R 2.00 66.35 12 5 100 500 91 82 58 27272:55
K2L2 New Static Addr 2.00 0.00 10 0 100 500 0 0 0 0:00
K2L2 New Multicast A 2.00 0.00 10 5 100 500 0 0 0 0:18
K2L2 Dynamic Address 2.00 0.00 10 5 100 500 0 0 0 0:16
K2L2 Vlan Table Revi 2.00 0.00 12 8 100 500 0 0 0 1:22
05-09-2011 01:46 AM
Hi,
Please check the below link describes troublshooting steps for C4500 Highe CPU,
http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00804cef15.shtml
Regards,
Mohamed
03-16-2015 01:07 PM
In most cases this is an indication that you have mac moves or a lot of learning going on. Check STP and enable "mac address-table notification mac-move" if you find that K2L2 Address Table R is running very hot in the "show platform health | ex 0.0" output.
(just putting this in so I can find it when I forget about this in a year.)
03-24-2015 10:59 AM
I had a VM server with 3 interfaces ( 6/15, 6/21, 6/23 ) in the Interface port-channel 60.
When a wrong configuration was put the interface 6/21 out of port-channel, the 4507 started to move mac and CPU went to 98% ( process K2L2 68% ).
When I put the interface 6/21 in the port-channel ( channel-group 60 mode on ) everything go back.
Now the CPU is 33%.
11-03-2011 05:59 AM
Hi,
We have same problem.
Did you solved this issue?
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide