Hello.
Need help.
After reboot cisco 6509, have a some problem.
First problem:
Some end user have problems with speed on interface vlan on 6509. For exsample user have a rate limit 3 mbit on interface, but real speed ~ 300 kbit. After shutdown/no shutdown interface vlan a problem dissapear.
And second problem on modul 6848-sfp with cpu utilization. Process fw_lcp load cpu over 50%.
Some info.
Core-WS-C6509-E#sh module
Mod Ports Card Type Model
--- ----- -------------------------------------- ------------------ -----------
3 48 CEF720 48 port 1000mb SFP WS-X6848-SFP
5 5 Supervisor Engine 2T 10GE w/ CTS (Hot) VS-SUP2T-10G
6 5 Supervisor Engine 2T 10GE w/ CTS (Acti VS-SUP2T-10G
Mod MAC addresses Hw Fw Sw Status
--- ---------------------------------- ------ ------------ ------------ -------
3 1.0 12.2(18r)S1 15.0(1)SY1 Ok
Core-WS-C6509-E#rem com m 3 sh proc cpu | e 0.00
CPU utilization for five seconds: 45%/0%; one minute: 47%; five minutes: 48%
PID Runtime(ms) Invoked uSecs 5Sec 1Min 5Min TTY Process
198 396093084 80464108 4922 39.83% 40.06% 40.09% 0 fw_lcp process
207 46086628 2890207 15945 4.71% 4.70% 4.73% 0 Lif stats hw rea
248 349408 300737 1161 0.07% 0.04% 0.05% 0 Hardware API bac
And for exsample 1 config int vlan.
Core-WS-C6509-E#sh ru | b Vlan830
interface Vlan830
description Energo
ip address 172.31.10.61 255.255.255.252
ip nat inside
service-policy input POLICY_RATE_LIMIT_2
service-policy output POLICY_RATE_LIMIT_2
Best regards, Sergey.
