cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
410
Views
0
Helpful
2
Replies
Highlighted
Participant

How do I remove this line from my 6500?

spanning-treemode rapid-pvst
spanning-tree extend system-id
no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340
spanning-tree vlan 1-2,100,110,120,130,140,150 priority 24576
spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672
diagnostic bootup level minimal
!

I don't want to have the second spanning-tree vlan line to show up at all.  They were added but we are changing and will not even have those VLANs on this switch.


I did the "no" command but it just added another annoying line of code.

Any suggestions?


James

1 ACCEPTED SOLUTION

Accepted Solutions
Beginner

Re: How do I remove this line from my 6500?

Try this in config mode:

no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672

spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340

That should do it.

View solution in original post

2 REPLIES 2
Highlighted
VIP Expert

Re: How do I remove this line from my 6500?

James,

If you are not able to remove all with one command, then try removing them one at the time

HTH

Reza

Beginner

Re: How do I remove this line from my 6500?

Try this in config mode:

no spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340 priority 28672

spanning-tree vlan 200,210,220,230,240,250,300,310,320,330,340

That should do it.

View solution in original post

CreatePlease to create content
Content for Community-Ad