How to configure an ACL that prioritizes traffic from one workstation?
There are 10 workstations continuously pinging an ISP router where the serial link's clock rate is 64000. How could I go about configuring an ACL that prioritizes traffic from only 1 workstation so that its packets aren't dropped?
Re: How to configure an ACL that prioritizes traffic from one workstation?
How would depend on the QoS policy which would actually prioritize the traffic. The ACL, itself, would likely match the host IP of the one workstation you wish to prioritize and further match a ping request or reply packet.
BTW, don't forget, to actually effectively prioritize any traffic, you often need to consider the packets flowing in both directions.
Hi, Is the port access or trunk mode? it has both config but which take precedence? What is the best command to verify? switchport access vlan 10switchport trunk encapsulation dot1qswitchport mode access
You have an extra week of fun! Capture the Flag has been extended through July 17. Register using the links below.
As a part of Cisco Live US auxiliary programs, we invite you to learn new technologies and obtain hands-on experience in a...
Hi,I'm trying to setup a cellular connection on my Cisco 1111 router.The interface is UP and it gets a private IPv4 and a public IPv6 address.If I try to send something on IPv4 through the cellular interface it works fine.But there seems to be an issue wi...
For an offline or printed copy of this document, simply choose ⋮ Options > Printer Friendly Page. You may then Print, Print to PDF or copy and paste to any other document format you like.