10-04-2009 11:28 PM - edited 03-06-2019 07:59 AM
Hi all.
please help!
i have a problem. i don't known command to enable Spanning tree portfast on Switch Cat2948G. please see information about IOS verison and Platform of device?
10-05-2009 12:12 AM
Hello Doan,
being IOS based
int type x/y
spanning-tree portfast
example
int f0/5
spanning-tree portfast
don't use it on ports towards other switches
Hope to help
Giuseppe
10-05-2009 05:33 AM
the Spanning-tree portfast command not exist on this IOS.
this is problem that i need all of you help.
this devices is 2948L3 and very old.
with you want add some port in to vlan, you must using "bridge-group " command.
10-05-2009 04:14 AM
Use "set port host" slot/port - port , such as 2/1-48 . The 2948G is a catos box.
10-05-2009 04:45 AM
Hello Glen,
in the attached sh ver:
System image file is "bootflash:cat2948g-in-mz.120-25.W5.27.bin"
this is an IOS box, isn't it?
Hope to help
Giuseppe
10-05-2009 04:54 AM
In one of cisco's smarter marketing moves they made a 2948G-L3 and 2948G layer 2 box which was based on the L2 cat 4000 box so you have basically have one or the other , the user would have to tell us what exactly he has. The L2 box actually runs Cat 4000 code. I went by the notion it said 2948G and not 2948G-L3 .
10-05-2009 05:08 AM
Hello Glen,
thanks
the scenario is the same as a C6500 in Hybrid mode there are actually two "devices" in the same box.
Best Regards
Giuseppe
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: