07-14-2014 08:27 AM - edited 03-07-2019 08:03 PM
07-14-2014 09:53 AM
Hey Rob,
Let us know what command is not accepted by system or where are you stuck?
I am adding a document for configuring SPAN and how to filter:
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/6_x/nx-os/system_management/configuration/guide/sm_nx_os_cg/sm_14span.html#pgfId-1313073
HTH.
Regards,
RS
07-15-2014 02:21 AM
HI,
Thanks for the reply.
Below is an output from the CLI menu (within the monitor session sub menu) - as u can see there is no filter vlan option. I cannot see anywhere else to add a filter option for an etherchannel trunk interface?
At the moment the monitor session is currently set to monitor the whole vlan123, however i want to monitor only vlan 123 on a specific etherchannel trunk interface.
Thanks
Rob
Nexus5548
version 5.2(1)N1(1b)
--------------------------------------------------------------
sw_hostname(config-monitor)# ?
description Session description (max 32 characters)
destination Destination configuration
mtu Set the MTU size for SPAN packets
no Negate a command or set its defaults
shut Shut a monitor session
source Source configuration
end Go to exec mode
exit Exit from command interpreter
pop Pop mode from stack or restore from name
push Push current mode to stack or save it under name
where Shows the cli context you are in
--------------------------------------------------------------
sw_hostname# show monitor session all
session 1
---------------
type : local
state : up
source intf :
rx :
tx :
both :
source VLANs :
rx : 123
source VSANs :
rx :
destination ports : Eth1/1
Legend: f = forwarding enabled, l = learning enabled
--------------------------------------------------------------
07-15-2014 10:30 AM
Hey Rob,
Unfortunately on Nexus5K traffic filtering options are very limited but an enhancement is already filed .And then it will allow to configure VACL for filtering, please have a look:
https://tools.cisco.com/bugsearch/bug/CSCtu14210
HTH.
Regards,
RS.
07-15-2014 01:15 PM
Hi,
Not quite the answer i was hoping for, but many thanks for taking the time to confirm the situation.
Guess it looks like i need to wait for a code update :(
Thanks again,
Rob
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: