z-core#show interfaces status
Port Name Status Vlan Duplex Speed Type
Te0/1 R-CORE connected trunk full 10G
Te0/2 M-CORE notconnect 1 full 10G
As you can see Type feild is emty, so I'm unable to find out transeiver's type e.g. 10GBASE-LR, 10GBASE-ER and etc. How to look into it's eeprom data?
Solved! Go to Solution.
Thanks, there's no such command on ME3800:
idb identity idmgr if-mgr
interfaces inventory ip ipam
ipc ipv6 isis
Cisco IOS Software, ME380x Software (ME380x-UNIVERSALK9-M), Version 15.2(4)S, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2012 by Cisco Systems, Inc.
Compiled Fri 20-Jul-12 18:52 by prod_rel_team
z-core#sh interface TenGigabitEthernet 0/1 transceiver properties
Name : Te0/1
Administrative Speed: 10000
Administrative Duplex: full
Administrative Auto-MDIX: on
Administrative Power Inline: N/A
Operational Speed: 10000
Operational Duplex: full
Operational Auto-MDIX: on
z-core#sh interface TenGigabitEthernet 0/2 transceiver ?
detail Show interface transceiver detail
properties Show interface transceiver properties
| Output modifiers
The output shows something but not what we expected. Neither "detail" did (just DOM statistics)
z-core#show inventory | begin "TenGigabitEthernet0/1"
NAME: "TenGigabitEthernet0/1", DESCR: ""
PID: SFP-10G-LR , VID: V02 , SN: ECL150902DA
NAME: "TenGigabitEthernet0/2", DESCR: ""
PID: SFP-10G-LR , VID: V01 , SN: T12110975
You are welcome. In this particular case all I need to know is the transceiver's type which is preprogrammed into its eeprom. Probably ME3800 retrieves only basic info for 'sh inventory' and does not support to view all data.