How to see 3850 PBR hits?

[malcolmsalmons]

Hi

I've recently deployed PBR on catalyst 3850s and everything looks to be working ok. However I'm not seeing hits on the ACL or Route-map. I'm using the following commands to try and see hits:

Show access-list

Show ip policy - to check its applied

Show route-map PBR_TRAFFIC

I can't see any hits under these and was wondering if the configs right or if I'm not using the correct command to verify hits. I seem to remember that on the 6500 you had to look in TCAM for hits and was wondering if this is something similar?

Thanks

Malcolm

[Emmanuel Valdez]

Hi,

Did you try with "show route-map" only? You have to see a similar output like this:

c2921_internet#sh route-map 

route-map INTERNET_INVITADOS, permit, sequence 10
  Match clauses:
    ip address (access-lists): 103 
  Set clauses:
    ip next-hop 10.1.100.3
  Policy routing matches: 2025356 packets, 206821491 bytes
route-map INTERNET_USUARIOS, permit, sequence 20
  Match clauses:
    ip address (access-lists): 102 
  Set clauses:
    ip next-hop 192.168.99.11
  Policy routing matches: 20253 packets, 206820 bytes

If it was useful please rate.

Regards.