How to see the present mac-table aging time/refresh time ?

[chandra_rc16]

Hi,

I want to know the present aging time of the below switch. And also the default againg time for a layer 2 2960 switch.

FYI: I'm using PT.

switch2#show mac-address-table ?

  dynamic     dynamic entry type

  interfaces  interface entry type

  static      static entry type

  <cr>

Regards,

Chandu

[Reza Sharifi · Accepted solution]

Hi,

Try this command on your switches:

sw1#sh mac address-table agi

sw1#sh mac address-table aging-time

Global Aging Time:  300

Vlan    Aging Time

----    ----------

sw1# sw1#sh mac address-table agi
sw1#sh mac address-table aging-time
Global Aging Time:  300
Vlan    Aging Time
----    ----------
sw1#

HTH

[chandra_rc16]

Thanks for you help. But may be it is not available in PT.

switch1#show mac-address-table aging-time

                               ^

% Invalid input detected at '^' marker.

Regards,

Chandu

[Reza Sharifi]

Hi,

You are trying:

switch1#show mac-address-table aging-time

try this:

sh mac address-table agi

no dash between mac and address

HTH

[chandra_rc16]

Hi Sharifi,

Still same.

switch1#sh mac address-table agi

               ^

% Invalid input detected at '^' marker.

switch1#

Regards,

Chandu