08-11-2019 01:52 AM - edited 08-11-2019 10:48 PM
Hello All,
This is my first time to ask some issue here !!!
Anyone who know how we can switch out of Recovery mode for Cisco 9500-16X series
Actually, I would like to do stacking on Cisco 9500-16x-A Series. I tried to learn from Cisco web site
But It couldn't work. So, anyone who can tell me what should i do when we need to do stacking on C9500?
with Dual Active mode
Best Regards,
08-11-2019 01:57 AM
08-11-2019 10:55 AM
I have followed the same document last week and it works as expected.
Can you elaborate, what is not working ? where do you stuck ? make sure you have console cable both the side so you can see the Logs and errors
Note : make sure domain is correct, some how when i was setting, suddendly switch to change to doamin 1 default - i have to correct that save config and reboot to working.
08-11-2019 11:25 PM
08-12-2019 02:09 AM
you need to make always modification on Active one once Stackwise Virtual Formed. what configuration which was not applied ?
08-13-2019 04:33 AM
Hi Balaji.bandi,
I had use command "show ver" then found that the register no. was 0x142 (will be 0x102 at next reload).
So, I was change register number to 0x102. Now, it's been fixed.
Best Regards,
08-13-2019 08:26 AM
Glad all working as expected, can you mark as solution if it resolved.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: