cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Ask the Expert- SD-WAN

269
Views
0
Helpful
6
Replies
Beginner

How to switch of out Recovery mode for Cisco 9500-16X series

Hello All, 

 

This is my first time to ask some issue here !!! 

Anyone who know how we can switch out of Recovery mode for Cisco 9500-16X series

Actually, I would like to do stacking on Cisco 9500-16x-A Series. I tried to learn from Cisco web site 

But It couldn't work. So, anyone who can tell me what should i do when we need to do stacking on C9500?

with Dual Active mode

 

Best Regards,

 

Everyone's tags (1)
6 REPLIES 6
Beginner

Re: How to switch of out Recovery mode for Cisco 9500-16X series

Actually, I wanna set Virtual stack by using Dual Active. Anyone who can let me know please
I had set as this cisco link:
https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/16-8/configuration_guide/ha/b_168_ha_9500_cg/b_168_ha_9500_cg_chapter_011.html#concept_sjb_byx_31b
but couldn't
VIP Advisor

Re: How to switch of out Recovery mode for Cisco 9500-16X series

I have followed the same document last week and it works as expected.

 

https://www.cisco.com/c/dam/en/us/products/collateral/switches/catalyst-9000/nb-06-cat-9k-stack-wp-cte-en.pdf

 

Can you elaborate, what is not working ? where do you stuck ? make sure you have console cable both the side  so you can see the Logs and errors

 

Note : make sure domain is correct, some how when i was setting, suddendly switch to change to doamin 1  default - i have to correct that save config and reboot to working.

BB
*** Rate All Helpful Responses ***
Beginner

Re: How to switch of out Recovery mode for Cisco 9500-16X series

Hi Balaji.bandi,

Thank you so much for the helping!!!!!
Switch# Role Mac Address Priority Version State
--------------------------------------------------------------------------------
-----
1 Standby xxx.xxx.xxx.xxx 15 V01 Ready
*2 Active xxx.xxx.xxx.xxx 14 V01 Ready

After I configure on the switch then reboot it. It's couldn't save the configure
What should I do on this?

Best Regards,






VIP Advisor

Re: How to switch of out Recovery mode for Cisco 9500-16X series

you need to make always modification on Active one once Stackwise Virtual Formed. what configuration which was not applied ?

BB
*** Rate All Helpful Responses ***
Beginner

Re: How to switch of out Recovery mode for Cisco 9500-16X series

Hi Balaji.bandi,

 

I had use command "show ver" then found that the register no. was 0x142 (will be 0x102 at next reload).

So, I was change register number to 0x102. Now, it's been fixed.

 

Best Regards,

Highlighted
VIP Advisor

Re: How to switch of out Recovery mode for Cisco 9500-16X series

Glad all working as expected, can you mark as solution if it resolved.

BB
*** Rate All Helpful Responses ***
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards