Solved: HWIC-1CE1T1-PRI

easylinktechnology · ‎08-01-2012

Dear brothers,

I have cisco2811 and HWIC-1CE1T1-PRI in the main office are using to connect 10 branches ( 10 ISDN lines) for Data.

I have available channels in the used E1 so I can use them for voice using PVDM2-64 ?

Thanks in advance for your support.

regards.

paolo bevilacqua · ‎08-01-2012

No. Digital voice on the HWIC-1CE1T1-PRI is supported only on ISR G2, and anway, does not allow support to data and voice in the same interface.

http://www.cisco.com/en/US/partner/docs/ios/12_4/12_4x/12_4_11xw/fmt1e1ic_voice.html#wp1058060

If you want to add voice capability on that router, yuo will need a two port VWIC or VWI2 card, connect one port to telco, the other to HWIC using a crossed cable, then configure dial-peer pots to send data calls to the latter.

View solution in original post

Sandeep Choudhary · ‎08-01-2012

Hi Muneer,

The problem here is that the HWIC-1CE1T1-PRI does not support Voice PRI's. You will want to use a VWIC.

http://www.cisco.com/en/US/prod/collateral/modules/ps2797/product_data_sheet0900aecd80710c88_ps5949_Products_Data_Sheet.html

Hope this helps!

Regards

Please rate if it helps.