04-16-2018 04:46 AM - edited 03-08-2019 02:40 PM
Hi there,
After updating the software on the stack and reload it, I couldn't see the Switch 2!, furthermore the mode on the other stack is installing mode but here shows me that the mode is BUNDLE as you can see:- Show version
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 56 WS-C3850-48P 16.3.6 CAT3K_CAA-UNIVERSALK9 BUNDLE
and when I typing show switch, its shows me that :-
Switch# Role Mac Address Priority Version State
------------------------------------------------------------
*1 Active cc5a.5369.0600 15 V07 Ready
2 Member 0000.0000.0000 0 Provisioned
please if you can give me an advice to solving this issue I'll purser that
Thanks a lot,
Solved! Go to Solution.
04-16-2018 05:00 AM
Hi there,
Console onto switch 2 and issue this command:
request platform software package expand switch all file flash:cat3k_caa-universalk9.16.03.06.SPA.bin
This will expand the bundle .bin file and should create flash:packages.conf. Reload the switch and it should come up in INSTALL mode.
cheers,
Seb.
04-16-2018 01:53 PM
If the second switch is in ROMmon then you'll need to perform an Emergency Recovery
04-16-2018 05:00 AM
Hi there,
Console onto switch 2 and issue this command:
request platform software package expand switch all file flash:cat3k_caa-universalk9.16.03.06.SPA.bin
This will expand the bundle .bin file and should create flash:packages.conf. Reload the switch and it should come up in INSTALL mode.
cheers,
Seb.
04-16-2018 01:53 PM
If the second switch is in ROMmon then you'll need to perform an Emergency Recovery
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide