cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
331
Views
0
Helpful
2
Replies

iBGP Redistribution issue

cdegroat82
Beginner
Beginner

Hi - Im currently running a GNS3 lab with 4 3640 routers.  I am running OSPF & BGP, OSPF to redistribute my connected subnets - and BGP to redistribute my static subnets.  3 out of the 4 seem to be working properly.  Core #1, 2 and 4 are receiving the proper static routes including the gateway of last resort.  However core #3, is only getting routes from Core #4 for some reason.  All BGP sessions are up and established.  Not really sure why its not working.

I attached the BGP configs and routing table outputs below.  Is there something Im missing?

2 Replies 2

cadet alain
VIP Alumni
VIP Alumni

Hi,

you haven't got a full mesh and iBGP won't advertise an iBGP learned route to another iBGP neighbour so routes learned from 1 and advertised to 2  and 4 won't get to 3.

you can see it when looking at the advertised routes  on Core 2 towards Core 3 for example with the following command:

sh bgp ipv4 unicast neighbour X.X.X.X advertised

Now it should receive prefixes of Core 2 and Core 4 but it would be easier to see what's happening with a diagramm and full configs from the routers.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

Ill take a screen shot of the diagram in a bit.  As for the full mesh that was the end goal - but I ran in to this issue first.  I ran sh bgp ipv4 unicast neighbour X.X.X.X advertised and see Core 1 advertising correctly to 2 and 4.  Doing some more reading - I see why Im having the issue, which is more or less the design of iBGP.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: