cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
449
Views
0
Helpful
3
Replies

ICND2 - Assign VLAN to Interface

cawinn
Cisco Employee
Cisco Employee

Hi All,

 

I'm adding a Voice VLAN to an interface with an existing data VLAN called Sales.

 

Do you know why the Voice VLAN doesn't appear with port Fa0/1 ?

 

Switch1(config)#interface Fa0/1
Switch1(config-if)#switchport voice vlan 3
Switch1(cofi-if)#exit
Switch1(config)#do show vlan

VLAN Name                             Status    Ports
---- -------------------------------- --------- ------------------------------
1    default                          active    Fa0/21, Fa0/22, Fa0/23, Fa0/24
2    Sales                            active    Fa0/1
3    Voice                            active   
1002 fddi-default                     act/unsup 
1003 token-ring-default               act/unsup 
1004 fddinet-default                  act/unsup 
1005 trnet-default                    act/unsup 

Switch1(config)#
3 Replies 3

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

Can you post the output of "sh run int fa01"?

 

Martin L
VIP
VIP

 

sh run int Fa0/1 , copy to notepad, add switchport voice vlan 3,

 

copy the whole config back to switch port. 

if that does not work; default int fa0/1, shut interface, add the whole config back to interface, no shut. 

 

is this a real switch ? if so , what is the model /ios?

Hello,

 

the port should show up in both VLANs. What platform is this on, and what IOS ?

 

interface FastEthernet0/1

switchport mode access

switchport access vlan 2

switchport voice vlan 3

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco