Hi,
I have been trying to configure a policy which limits a specific VLAN or subnet to X amount of bandwidth however i am having issues with the inbound and outbound working on a single device.
For example we have two subnets.
VLAN 101 (10.10.10.0/24) and VLAN 102 (11.11.11.0/24), VLAN 101 is to have 5mbps with 1 mbps burst and VLAN 102 is to have 15mbps and 3 mbps burst.
I run into the issue where the QoS policy does not apply in both directions.
A brief topology is below:
Customer site ------> Customer firewall (FWSM) ---------------> 7606 ---------------------> ASR1000
LAN VLAN101 (10.10.10.2) 10.10.10.1 default route---> (intenet router)
(VLAN interface)
We would ideally like to do all QoS on the ASR if possible.
Regards,
Scott