cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1120
Views
15
Helpful
6
Replies
Highlighted
Explorer

invalid mask?

I am configuring a Supervisor 2T with the vlan interface

192.168.94.1 255.255.255..192

and it is giving me the error "bad mask" (won't accept)

ip classless is enable, and ip subnet-zero is a default yes?

Why isn't it taking that network? isn't it valid? (192.168.94.1 - 63 /26)

6 REPLIES 6
Highlighted
Hall of Fame Community Legend

invalid mask?

Maybe it's overlapping something already there.

Can you post the output to the command "sh run | i 192.168".

Highlighted
Beginner

Re: invalid mask?

If the same subnet is being used on another interface you will get a different message
Are you sure this is not because of a typo? I see there are two dots in "..192"

Sent from Cisco Technical Support iPhone App

Highlighted
Explorer

invalid mask?

above was a typo: it is 192.168.94.1

I will check on Monday to see if it is overlapping: really weird that I am getting this

Highlighted
Rising star

Re: invalid mask?

Hello Colin,

pleae refer to the below:

network address is: 192.168.94.0

first host is : 192.168.94. 1

last host is : 192.168.94.62

Subnet mask is : 255.255.255.192

your host range is from (1 to 62)  the next IP address 192.168.94.63 is broadcast address. by then you cannot assign this ip address to your hosts.

briefly you have assign from (192.168.94.1 to 192.168.94.62).

this is correct, if this is an interface of a router, but if you have a MLS; befor you assign any IP aadress you have to apply CLI (no switchport).

regards,                             

                                                                                                       **Please grade this post if you find it useful.

Beginner

invalid mask?

Please provide the following -

show version

show module

configuration that you do in the interface mode along with the error message you get

Highlighted
Hall of Fame Master

invalid mask?

I agree that the error bad mask is not the result of overlapping addresses. It typically caused by attempting to use the subnet address, the broadcast address, subnet zero not enabled, or perhaps some typo in the address.

I would like to see the output of show ip interface for the interface in question. I think that the output of show ip protocol might also be helpful.

HTH

Rick

HTH

Rick
CreatePlease to create content
Content for Community-Ad