iOS upgrade for WS-C4948-10GE ipbase to enterprise
I am trying to upgrade my WS-C4948-10GE from ipbase (cat4500-ipbase-mz.122-46.SG.bin) to enterprise (cat4500-entservicesk9-mz.122-54.SG1.bin) so that I can run some BGP routing. I pulled the code from Cisco, tftp'd to the switch ensured the conf-reg is correct (0x2102) and set the boot system flash command to point to the enterprise code.
on reboot the switch tries to load the new code but gets stuck at:
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...