Running "show ip pim config-sanity" reports the following error for an RP that I've configured but I cannot see whats causing the error.
PIM Configuration check to catch any obvious errors in vrf default
Finding local Static RPs PIM config errors...
RP Address-10.1.1.193
Finding local Anycasts RPs PIM config errors...
Finding BSR config errors...
Finding Auto-RP config errors...
The RP has been configured for anycast on a pair of Nexus 3548 switches. The relevant config for switch A is as follows
interface loopback0
ip address 10.1.1.193/32
ip pim sparse-mode
interface loopback1
ip address 10.1.1.194/32
ip pim sparse-mode
ip pim rp-address 10.1.1.193 group-list 239.255.0.0/24
ip pim anycast-rp 10.1.1.193 10.1.1.194
ip pim anycast-rp 10.1.1.193 10.1.1.195
The relevant config for switch B is as follows
interface loopback0
ip address 10.1.1.193/32
ip pim sparse-mode
interface loopback1
ip address 10.1.1.195/32
ip pim sparse-mode
ip pim rp-address 10.1.1.193 group-list 239.255.0.0/24
ip pim anycast-rp 10.1.1.193 10.1.1.194
ip pim anycast-rp 10.1.1.193 10.1.1.195
Running "sh ip pim int lo0" on both switches reports "loopback0, Interface status: protocol-up/link-up/admin-up"
I can't see why "show ip pim config-sanity" is reporting the RP 10.1.1.193 as a static RP rather than an anycast-RP and specifically what has been missed in the config to cause this to flag up as an error.