cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
505
Views
0
Helpful
3
Replies

ip policy route-map does not working

csco11579831
Level 1
Level 1

Hi,

I tried to apply the ip policy route-map command to an interface vlan X, but is not working.

Switch Ports Model              SW Version            SW Image                

------ ----- -----              ----------            ----------              

*    1 30    WS-C3750X-24       15.0(2)SE1            C3750E-UNIVERSALK9-M    

     2 30    WS-C3750X-24       15.0(2)SE1            C3750E-UNIVERSALK9-M    

3 Replies 3

cadet alain
VIP Alumni
VIP Alumni

Hi,

1° make sure you've got the IP services image installed on the master  with show licence

2° show sdm prefer and change your SDM template to  sdm prefer routing  if needed  then reload and verify with show sdm prefer again.

Regards

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

In addition to the good points that Alain makes I would ask that you provide some details of how you have configured Policy Based Routing. One common mistake is to apply the route map on the exit interface when that is required is to apply the route map on the interface on which traffic arrives. So if we can see what you have configured we can determine whether it is an issue like that.

HTH

Rick

HTH

Rick

csco11579831
Level 1
Level 1

Hi all,

HOSTKJ1#sh license

Index 1 Feature: ipservices    

        Period left: 8  weeks 4  days

        License Type: Evaluation

        License State: Active, Not in Use, EULA not accepted

        License Priority: None

        License Count: Non-Counted

Index 2 Feature: ipbase        

        Period left: Life time

        License Type: Permanent

        License State: Active, In Use

        License Priority: Medium

        License Count: Non-Counted

Index 3 Feature: lanbase       

        Period left: Life time

        License Type: Permanent

        License State: Active, Not in Use

        License Priority: Medium

        License Count: Non-Counted

HOSTKJ1#sh version

License Level: ipbase

License Type: Permanent

Next reload license Level: ipbase

I only have a license IP base

how to proceed in order to obtain one ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco